For premium performance without the premium price of a dedicated power shear, TURBOSHEAR HD is an easy addition to every tool box.

    * Inserts into chuck of 14.4 volt or larger A/C or cordless drill

    * Clamping devise is standard with No. TSHD TurboShear

    * Navigates tight patterns and square cuts

    * Cuts a variety of building materials with the ability to reposition upside down for greater maneuverability

    * 18 gauge capacity in galvanized steel

    * Long-life, dual ball bearings

TSHD - cuts 18-gauge (1.32 mm) galvanized steel (HVAC duct work, auto body panels), 20-gauge (.82 mm) non hardened carbon steel and stainless steel (metal roofing panels), 14-gauge (1.54 mm) aluminum (trim coil, flashing), and .100 inch (2.55 mm) copper (metal roofing, gutters).

The TSHD is also rated to cut 20-gauge (.82 mm) spiral duct work.

TSHD - The Turboshear metal cutting series will make clean cuts throughout the range of thicknesses of material listed above. The tool will need to be adjusted when going from very thin to thick material and vice versa.

TSHD - The clearance between the cutting jaws is adjustable in order to achieve the optimum cut for thick or thin material. To adjust, locate the 3/16” set screw on the back of the tool, towards the front of the tool near the jaws. Turn it clockwise to tighten the gap of the jaws for thinner material or counterclockwise to make the gap of the jaws larger for thicker material.